BALDR B0340WST2H2R-V7 Manual Del Usuario página 7

Note:
1. Main unit will auto receive outdoor signal after power on, the
receiving status will last for max 3 minutes. The receiving anten-
na signal will flash. If no signal received in 3 minutes, it will stop
receiving outdoor signal.
2. If the main unit is out of 3 minutes' signal receiving window, you
need to press and hold the " CH/▲" button to enter signal
receiving again.
MAIN UNIT SETUP
When power on or reset, LCD will full display for 3 seconds with
"BI" sound. Then display Indoor temperature and humidity with
100% backlight brightness.
RF Signal Receiving
After power on, It will start receiving outdoor sensors' signal for 3
minutes. If all 3 channels signal received within 3 minutes or receiv-
ing window ends, it will enter into DCF Signal Receiving window.
DCF Signal Receiving
1. After RF signal receiving, it will start searching radio signal for 7
minutes with the antenna symbol "
2. Once signal received, the main unit will display the received
time/month/date/weekday with symbol "
screen.
3. Daily RCC signal receiving: there are regular radio signal receiv-
ing at 1:00AM,2:00AM, 3:00AM, 4:00AM, 5:00AM each day. It
starts receiving signal at 1:00AM everyday. For each day, once
signal received at any one receiving time, it will stop receiving
signal that day.
4. Manual receiving: press " RCC/ SET " button to enter RCC
signal receiving.
5. During receiving,you can press " RCC/ SET " button to exit RCC
receiving.
" flashing on screen.
7
" displaying on