Manual Settings - BALDR B0340WST2H2R-V7 Manual Del Usuario

* RCC symbol display:
a. When receiving signal , RCC symbol "
by "1HZ".
b. When signal successfully received, LCD will display complete
RCC symbol "
c. If no signal is received, the RCC symbol will disappear.

Manual Settings

1. After signal received, if there is no need for other settings, you
can just finish reading here. If there is other setting requirements.
Please check the following steps. Or if there is no signal
received, you can follow bellow steps for Manual Setting.
2. Press and hold " RCC/SET " button to enter into setting, press
" RCC/SET " button to skip setting steps or go to the next
setting option.
*Tips: press and hold " CH/▲ " or " MEM/▼ "button will quickly
change the value by 8 steps.
3. Press " RCC/SET " to select the RCC. Default setting : ON.
Press the " CH/▲" or " MEM/▼" button to select OFF or ON.
4. Press " RCC/SET " to select Time Zone. Default setting : 00.
Press " CH/▲" or " MEM/▼" button to select time zone from
-12 H to + 12 H.
5. Press " RCC/SET " to select 12/24H Time Format. Default setting :
24 H. Press the " CH/▲" or " MEM/▼ " button to select 12H or 24H.
6.
Press " RCC/SET " to select Hours. Press " CH/▲" or " MEM/▼"
button to adjust the value.
7.
Press " RCC/SET " to select Minutes. Press " CH/▲" or
" MEM/▼" button to adjust the value.
8. Press " RCC/SET " to select Year. Setting range: 2000-2099.Press
" CH/▲" or " MEM/▼" button to adjust the value.
9. Press " RCC/SET " to select Month & Date display format. Default
setting : D/M. Press the " CH/▲" or " MEM/▼" button to select
M/D or D/M format. (M: Month ,D: Date)
10. Press " RCC/SET " to select the Month. Press " CH/▲" or
" MEM/▼" button to adjust the value
11. Press " RCC/SET " to select the Date. Press " CH/▲" or
" MEM/▼" button to adjust the value.
" and exit RCC receiving.
8
" will be flashing