Rola 59976 Manual Del Usuario página 8

INSTALLATION INSTRUCTIONS
4. Slide the RBU end supports into the rails and leave loose until set into place on the
vehicle's raised side rails. Fig. B.
Fig. B
5. Position the cross bars onto the vehicle side rails using measurements "Y" & "Z". Fig. C.
Once on the car, position the cross bars to have equal amounts of overhang per side "X"
after pushing the end support against the vehicle's rail. Fig. D.
X
Roof
Fig. C
Fig. D
Tip: place bar upside down for
easier handling of parts
Y
Y
1
Lower over rail.
Z
X
Rail
2
Then push against rail.
59976N Rev B • Questions? (800) 234-6992 • ROLAProducts.com
PAGE 8