Additional Safety Warnings; Intended Use - Würth 5706 102 Serie Manual De Instrucciones

 Do not use accessories not specifically
intended and recommended for this
power tool by Würth. Safe operation is not
ensured only because an accessory fits your power
tool.
 Grasp the power tool in such a safe man-
ner that your body never comes into con-
tact with the application tool, especially
while working with application tools
such as saw blades or other blades
pointed toward the grasping range.
Touching sharp tips or cutting edges can lead to
injuries.
 Wear personal protective equipment.
Depending on application, use face
shield, safety goggles or safety glasses.
Where appropriate, wear dust mask,
hearing protectors, gloves and work-
shop apron capable of stopping small
abrasive or workpiece fragments. The eye
protection must be capable of stopping flying
debris generated by various operations. The dust
mask or respirator must be capable of filtrating par-
ticles generated by your operation. Prolonged
exposure to high intensity noise may cause hearing
loss.
Hand-guided oscillator for use without water supply in
weather-protected environments using the application
tools and accessories recommended by Würth.
Construction
• for sawing wood (max. 78 mm), plastic, glass-fibre
reinforced plastics (GFRP, CFP) and for sawing
sheet metal (max. 1 mm)
• for removing tile joints and rasping or scraping off
tile grout or carpet remainders
• for cutting elastic sealants (silicone or acrylic) on
facades/frontages and for roughing groove faces
• for sanding or rasping of smaller surfaces
 Do not direct the power tool against your-
self, other persons or animals. Danger of
injury from sharp or hot application tools.
 Do not rivet or screw any name-plates or
signs onto the power tool. If the insulation is
damaged, protection against an electric shock will
be ineffective. Adhesive labels are recommended.
 Clean the ventilation openings on the
power tool at regular intervals using non-
metal tools. The blower of the motor draws dust
into the housing. An excessive accumulation of
metallic dust can cause an electrical hazard.
 Before putting into operation, check the mains con-
nection and the mains plug for damage.
 Recommendation: The tool should always be sup-
plied with power via a residual current device
(RCD) with a rated current of 30 mA or less.

Additional safety warnings

 Use only original Würth accessories.

Intended Use

This power tool is also suitable for use with AC gener-
ators with sufficient power output that correspond to
the Standard ISO 8528, design type G2. This Stand-
ard is particularly not complied with when the so-called
distortion factor exceeds 10 %. When in doubt, please
refer to the generator instruction/specification guide.
For damage caused by usage other than intended, the
user is responsible.
Changing the tool (see pages 5/6).
 Do not use accessories not specifically
intended and recommended for this
power tool by Würth. Using accessories not
recommended or authorised by Würth can lead to
overheating or destroy the power tool.
When changing application tools with sharp cut-
ting edges, use cover 3 21 74 011 00 0 to pro-
tect yourself against hand injuries.
The machine must not be damp
and must also not be operated in
damp suroundings.
Operating Instructions
20