Additional Safety Warnings; Intended Use - Würth EMS 350-SL COMPACT Traducción Del Manual De Instrucciones De Servicio Original

OBJ_BUCH-0000000265-001.book Page 17 Monday, August 1, 2016 4:08 PM
 Grasp the power tool in such a safe man-
ner that your body never comes into con-
tact with the application tool, especially
while working with application tools
such as saw blades or other blades
pointed toward the grasping range.
Touching sharp tips or cutting edges can lead to
injuries.
 Wear personal protective equipment.
Depending on application, use face
shield, safety goggles or safety glasses.
Where appropriate, wear dust mask,
hearing protectors, gloves and work-
shop apron capable of stopping small
abrasive or workpiece fragments. The eye
protection must be capable of stopping flying
debris generated by various operations. The dust
mask or respirator must be capable of filtrating par-
ticles generated by your operation. Prolonged
exposure to high intensity noise may cause hearing
loss.
 Do not direct the power tool against your-
self, other persons or animals. Danger of
injury from sharp or hot application tools.

Intended Use

Hand-guided oscillator for sanding small surfaces, cor-
ners and edges, for sawing thin parts of steel sheet,
wood and plastic, for scraping, polishing, rasping, cut-
ting and separating without water in weather-protected
environments, using the application tools and accesso-
ries recommended by Würth.
For damage caused by usage other than intended, the
user is responsible.
Operating Instructions
 Do not use accessories not specifically
intended and recommended for this
power tool by Würth. The use of non-original
Würth accessories can lead to overheating of the
power tool and destroy it.
Changing the tool (see pages 4/5).
Do not switch the power tool on while
the clamping lever is open. Otherwise there
is danger of crushes or contusions to the hand and
fingers.
 Do not rivet or screw any name-plates or
signs onto the power tool. If the insulation is
damaged, protection against an electric shock will
be ineffective. Adhesive labels are recommended.
 Clean the ventilation openings on the
power tool at regular intervals using non-
metal tools. The blower of the motor draws dust
into the housing. An excessive accumulation of
metallic dust can cause an electrical hazard.
 Before putting into operation, check the mains con-
nection and the mains plug for damage.
 Recommendation: The tool should always be sup-
plied with power via a residual current device
(RCD) with a rated current of 30 mA or less.

Additional safety warnings

The machine must not be damp
and must also not be operated in
damp suroundings.
 Use only original Würth accessories.
Do not reach into the area of the clamp-
ing jaws. Otherwise there is danger of crushes
or contusions to the fingers.
Additional operating instructions.
Do not actuate the clamping lever while
the power tool is running. Otherwise there
is danger of injury.
Do not operate the power tool with with
open clamping jaws and without an
application tool! This could damage the power
tool.
When the clamping jaws are open
before the application tool is inserted,
pivot the clamping lever toward the front
and then back again. The clamping jaws are
closed now. The application tool can be inserted.
Guide the power tool toward the work piece only
when switched on.
The application tool can be offset in 30° steps and fas-
tened in the most favourable working position.
17