System Check - Bulldog DC Serie Manual De Instrucciones

Installation Instructions

1.7.4 System Check

Upon completion of installation, check winch for proper operation. The voltage drop for the winch
motor must not exceed 10% of the nominal voltage of 12/24 DC.
Figure 15 - DC9000, DC12000L, DC12000, DC15000, & DC18000 Wiring Diagram
Figure 16 - DC6000 Wiring Diagram
1.7.5 Sealed Reversing Contactor Installation
WARNING
1. Disconnect the power from your winch prior to performing any maintenance or otherwise servicing
your winch.
2. Remove the control box from its mounts.
3. Remove the screws from either side of the control box and remove the cover.
4. Take a picture of the contactor and the wire placement. Disconnect the wires from the contactor.
5. Remove the contactor from the control box.
6. Replace the contactor.
7. Replace the wires to the contactor. Use the wiring diagrams or your photo as a reference.
8. Reattach the control box cover.
9. Remount the control box.
10. Reconnect power to your winch.
14
CEQUENT PERFORMANCE PRODUCTS, INC. •
™
F3838-00 REV C (4782) 7/15