Philips HC8850 Manual De Instrucciones página 7

XP SBC HC 8850/00-1
Installation
Notes:
Completely flat batteries need approximately
16 hours to recharge.
The FM headphone will switch off
automatically during recharging.
Always remove the batteries if the
headphone is not to be used for a long period
of time.
Batteries contain chemical substances,
so they should be disposed of properly.
Headphone battery
replacement (figure 3)
IMPORTANT
Use only rechargeable R03/AAA NiMH
batteries (preferably Philips).
Do not use NiCd batteries or
alkaline batteries as these may damage
your FM wireless system!
1 Remove the earcushions.
2 Take out the batteries and dispose of them
properly.
3 Insert new batteries. Only use R03/AAA
NiMH batteries (preferably Philips).
4 Make sure the batteries are correctly
inserted as indicated by the engraved
symbols in the battery compartment.
5 Put the earcushions back on the earshells.
IMPORTANT
Before using the FM headphone for the
first time, please ensure that the
batteries are fully charged for about
16 hours.This will guarantee a longer
operating lifetime of the batteries.
19-03-2002 14:45 Pagina 7
Audio Connections
Audio Connections
IMPORTANT
Use only 1 of the audio inputs:
3.5 mm stereo headphone audio input
OR the line audio input!
Using both audio inputs at the same
time may damage your FM wireless
system or your audio source!
Option 1 (figure 4)
Connecting the FM transmitter to a line
output of an audio source, e.g. REC OUT,
LINE OUT.
1 Connect the 3.5mm stereo plug of the
stereo audio cable to the FM transmitter's
3.5mm headphone input.
2 Connect the 2 RCA plugs of the stereo
audio cable to a line output (REC OUT or
LINE OUT) of an audio source, e.g.TV, HiFi
or PC:
– Check if the red RCA plug (right
channel) is connected to the right
channel (red) of the audio source.
– Check if the white RCA plug (left
channel) is connected to the left channel
(white) of the audio source.
3 Switch on your audio source.The red
power indication LED of the transmitter
lights up if receiving an audio signal.
4 In case the line output of the audio source
has an adjustable output level, adjust the
line output level of the audio source to the
highest acceptable undistorted level.
5 Switch on the headphone.You may hear a
hissing sound through the headphone if the
headphone is not yet properly tuned to the
transmitter.
6 To tune, press and hold the tuning control
button for about 1 second. Repeat if
necessary until the red tuning indication
lights up.
7