Steam Jet - Water Spray; Dry Ironing; Cleaning; Before Storing - TREVIDEA G3 Ferrari VISIR G40012 Manual Del Usuario

STEAM JET – WATER SPRAY
Steam jet
: press the steam-shot button (4) for having a vigorous jet of steam which can penetrate the fibers
and soften even the most stubborn creases. Wait a few seconds before pressing.
By pressing the button periodically is also possible to freshen up curtains, hanging clothes, etc ...
Caution: the steam shot function can only be used at high temperatures; stop the jet when the temperature
control light lights up, start again when it goes out.
Water spray
: press the water spray button (5) slowly for having dense spray; press fast for vaporized spray.
Caution: make sure there is water in the tank. For delicate fibers it is advisable to moisten the article before
using the spray. To prevent stains, do not use the spray over silk and synthetic fibers.

DRY IRONING

To perform dry ironing, move the steam regulator (3) in "0" position. In this position, the steam emission is
disable, otherwise the water spray option is still unable.

CLEANING

Before cleaning any part of the product, ensure that the unit is unplugged from the electrical outlet and
the ironing plate isn't hot anymore.
Any leftovers on the ironing plate can be removed with a damp cloth or with a non-abrasive detergents. Do
not scrape the ironing plate with iron sponge or metal objects.
The plastic parts can be cleaned with a damp cloth and neutral detergent, then wiped with a dry cloth. Do not
immerse the unit in water.
Self-cleaning
: the use of this function every 10-15 days is recommended. The auto-cleaning removes
impurities and lime scales inside the holes of the plate. Follow the steps:
•
Fill the tank up to the maximum level and place the steam regulator (3) to "0".
•
Set the temperature controller (9) up to the maximum (MAX) and wait for the control light (6) to turn
off.
•
Disconnect the power plug from the socket and hold the iron horizontally over a sink.
•
Press and hold self-cleaning button (10) until all the water and steam come out.
•
When the plate has cooled down, wipe it with a damp cloth.

BEFORE STORING

•
Unplug the system from the outlet.
•
Empty the water tank by turning the device upside down and shake it gently.
•
Allow the plate to cool down completely.
•
Wrap the power cord in the back of the body.
•
Leave the electric iron vertically.

TECHNICAL FEATURES

•
Power supply: AC 230V~50 Hz. 2500W power
•
Water tank capacity: 300 ml
WASTE OF ELECTRIC AND ELECTRONIC EQUIPMENT
The product is made of non-biodegradable and potentially polluting substances if not properly disposed of;
other parts can be recycled. It's our duty to contribute to the ecological health of the environment following
the correct procedures for disposal. The crossed out wheelie bin symbol indicates the product complies with
the requirements of the new directives introduced to protect the environment (2002/96/EC, 2003/108/EC,
2002/95/EC, 2012/19/EC) and must be properly disposed at the end of its lifetime. If you need further
information, ask for the dedicated waste disposal areas at your place of residence. Who does not dispose of
the product as specified in this section shall be liable according to the law.
14