Accessories, Consumables; Technical Data - Hilti SC 70W-A Manual De Instrucciones

1 Hexagon socket wrench
1 Rip fence (parallel guide)
1 Guide rail adapter (optional)
3.3 Additional items required for operating the tool:
en
A suitable battery of the specified type (see table in the Technical Data section) and a suitable battery charger from
the C 4⁄36 series. For further information about battery charging, please read the operating instructions for the battery
charger.
3.4 Lithium‑ion battery charge status
The Li-ion battery features a charge status display. The charge status is indicated by the LEDs on the battery during
charging (please refer to the operating instructions for the charger). When the battery is not in use, pressing one of the
battery release buttons or inserting the battery into the power tool causes the battery charge status to be displayed
by the four LEDs for three seconds.
LEDs light constantly
LED 1, 2, 3, 4
LED 1, 2, 3
LED 1, 2
LED 1
-
NOTE
Indication of the charge status is not possible while the power tool is in operation or immediately after operation. If the
battery charge status LEDs flash, please refer to the information given in section 9. "Troubleshooting".

4 Accessories, consumables

NOTE
Accessories can be found at your Hilti Center or online at www.hilti.com.
Spare parts
Designation
Mounting flange
Clamping flange
Clamping screw

5 Technical data

Right of technical changes reserved.
Power tool
Rated voltage (DC voltage)
Weight in accordance with EPTA procedure 01/2003,
with large base plate
Weight in accordance with EPTA procedure 01/2003,
with small base plate
Specified blade diameter
Saw blade disc thickness
Saw blade arbor size
6
LEDs blink
-
-
-
-
LED 1
SC 70W‑A22
21.6 V
4.7 kg
4.5 kg
190 mm
0.7...1.5 mm
30 mm
Charge status C
C ≧ 75 %
50 % ≦ C < 75 %
25 % ≦ C < 50 %
10 % ≦ C < 25 %
C < 10 %