Selecting Functions - CAME ZG6 Manual De Instrucciones

Activating the remote control
-Connect the antenna's RG58 cable to the apposite terminals.
-Lock the radiofrequency card into the electronic card
N.B.: the electronic card only recognises the radiofrequency card when the power is on.
Memorizing the code on the command board
A
-Keep the "PROG" button on the electronic card pressed. The LED fl ashes.
-Press the transmitter button you wish to memorise. The LED will stay on to show memorisation has been successful.

Selecting functions

E
1 ON Automatic closing function activated; (1 OFF-deactivated);
2 ON "Open" function with activated remote control (HF board inserted);
2 OFF "Open-close-reverse" function with pushbutton (2-7) and activated remote control (HF board inserted) ;
3 ON "Maintained Action" function (remote control function disabled) activated; (3 OFF deactivated);
4 ON Activated pre-fl ashing during opening and closing,, with device connected on terminals 10- E6 (4 OFF deactivated);
5 ON Obstacle detection. With the motor off (bar closed, open or after a total-stop command), movement is blocked if safety devices
(e.g. photoelectric cells) detect an obstacle;
6 OFF Total stop function activated, connect pushbutton to 1-2 (if not set the dipswitch to ON);
7 OFF Reopening function during closure activated, connect the safety devices to terminals 2-C1 (if not used set the dipswitch to ON);
8 ON Safety test function to check photoelectric cell effi ciency (page.7) activated; (8 OFF deactivated).
9 OFF Encoder activated for obstacle detection (9 ON deactivated);
10 ON Activates the intermittence function during movement - device hooked up to 10-E6.
10 OFF Activates the intermittence function when bar is closed - device hooked up to 10-E6.
The data and information reported in this installation manual are susceptible to change at any time and without obligation on CAME cancelli automatici s.p.a. to notify users.
D
AFTER CUTTING OFF THE POWER SUPPLY (or after disconnecting the batteries).
B