DeWalt DXGHT22 Manual Del Operador página 13

ASSEMBLY
Installing and Removing the
Attachment
The coupler enables the use of various optional
attachments.
WARNING:
attachment, read and understand
the manual that came with the
attachment. Follow all safety
information contained within.
WARNING:
personal injury and damage to the
unit, shut the unit off before
removing or installing an attachment.
Installing the Attachment
1. Remove the hanger cap from the
attachment. Keep the hanger cap for use
when storing the attachment. If present,
remove the gray spacer from the coupler.
2. Set the unit on a flat, level surface.
3. Turn the knob counterclockwise to loosen
the coupler (Fig. 1).
Tighten
Before using any
To avoid serious
4. Push the attachment straight into the
coupler (Fig. 2) until the release button
snaps firmly into the 90˚ hole (Fig. 3).
5. Turn the knob clockwise to tighten the
coupler (Fig. 1).
WARNING:
unit, make sure the release button is
fully snapped into the 90˚ hole and
the knob is securely tightened.
WARNING:
otherwise, the release button should
be snapped into the 90˚ hole only.
Using the wrong hole could lead to
personal injury or damage to the unit.
Removing the Attachment
1. Set the unit on a flat, level surface.
2. Turn the knob counterclockwise to loosen
the coupler (Fig. 1).
3. Press and hold the release button (Fig. 3).
4. Pull the attachment straight out of the
coupler (Fig. 2).
Loosen
Fig. 1
13
Before operating the
Unless specified
Knob
ENGLISH