Maintenance Schedule - DeWalt DXGHT22 Manual Del Operador

OPERATION - Continued
Angle Adjustment
Shaft Housing
MAINTENANCE
WARNING:
personal injury, always stop the
engine and allow it to cool before
cleaning or maintaining the unit.
Never perform cleaning or
maintenance while the unit is
running. Disconnect the spark plug
wire to prevent the unit from starting
accidentally.
WARNING:
clothing and observe all safety
instructions to prevent serious
personal injury.

Maintenance Schedule

Perform these required maintenance procedures
at the frequency stated in the table. These
procedures should also be a part of any seasonal
tune-up.
NOTE: Some maintenance procedures may
require special tools or skills. If you are
unsure about these procedures, take the
unit to an authorized service dealer. Call
1-855-971-1123 for more information.
Indexing Ring
Handle
To avoid serious
Wear protective
Locking Pin
Adjustment Lever
Fig. 15
NOTE: Maintenance, replacement, or repair of
the emission control devices and system
may be performed by an authorized
service dealer. Call 1-855-971-1123 for
more information.
NOTE: Please read the California/EPA statement
that came with the unit for a complete
listing of terms and coverage for the
emissions control devices, such as the
spark arrestor, muffler, carburetor, etc.
FREQUENCY
Every 10
hours
After the first
10 hours, at
50 hours, and
at 100 hours
23
Indexing Hole
MAINTENANCE REQUIRED
• Clean and re-oil the air
filter. Refer to
Maintaining the Air Filter.
• Check the spark plug
condition and gap. Refer
to Maintaining the Spark
Plug.
ENGLISH