Stryker SYSTEM G Manual Del Usuario página 13

EN
Recommended separation distances between portable and mobile RF communications equipment and the STRYKER SYSTEM G Sagittal Saw (REF
The STRYKER SYSTEM G Sagittal Saw (REF 7308-001-000) is intended for use in the electromagnetic environment in which radiated RF disturbances
are controlled. The customer or the user of the STRYKER SYSTEM G Sagittal Saw (REF 7308-001-000) can help prevent electromagnetic interference by
maintaining a minimum distance between portable and mobile RF communications equipment (transmitters) and the STRYKER SYSTEM G Sagittal Saw
(REF 7308-001-000) as recommended below, according to the maximum output power of the communications equipment.
Rated maximum output power of
transmitter
W
0.01
0.1
1
10
100
For transmitters rated at a maximum output power not listed above, the recommended separation distance d in meters (m) can be estimated using the
equation applicable to the frequency of the transmitter, where P is the maximum output power rating of the transmitter in watts (W) according to the
transmitter manufacturer.
NOTE 1: At 80 MHz and 800MHz, the separation distance for the higher frequency range applies.
NOTE 2: These guidelines may not apply in all situations. Electromagnetic propagation is affected by absorption and reflection from structures, objects and
people.
12
7308-001-000)
Separation distance according to frequency of transmitter
150 kHz to 80 MHz
0.12
0.38
1.2
3.8
12
m
80 MHz to 800 MHz
0.12
0.38
1.2
3.8
12
7308-001-700 Rev-A
800 MHz to 2.5 GHz
0.23
0.73
2.3
7.3
23
www.stryker.com