9. Lower the cover back in place.
10. Lock the jam clearing latch.
If nails become jammed in the nosepiece
frequently, have the tool serviced by an authorised
D
WALT service centre.
E
MAINTENANCE
Your D
WALT power tool has been designed to
E
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
WARNING: To reduce the risk of
serious personal injury, turn tool
off and disconnect battery pack
before making any adjustments or
removing/installing attachments or
accessories. An accidental start-up
can cause injury.
The charger is not serviceable. There are no
serviceable parts inside the charger.
Lubrication
Your power tool requires no additional lubrication.
NOTICE: Do not
lubricate the tool as
it will damage the
internal parts.
Cleaning
WARNING: Blow dirt and dust out of
the main housing with dry air as often as
dirt is seen collecting in and around the
air vents. Wear approved eye protection
and approved dust mask when
performing this procedure.
WARNING: Never use solvents or
other harsh chemicals for cleaning the
non-metallic parts of the tool. These
chemicals may weaken the materials
used in these parts. Use a cloth
dampened only with water and mild
soap. Never let any liquid get inside the
tool; never immerse any part of the tool
into a liquid.
CHARGER CLEANING INSTRUCTIONS
WARNING: Shock hazard. Disconnect
the charger from the AC outlet before
cleaning. Dirt and grease may be
removed from the exterior of the charger
using a cloth or soft non-metallic brush.
Do not use water or any cleaning
solutions.
Optional Accessories
WARNING: Since accessories, other
than those offered by D
not been tested with this product, use
of such accessories with this tool could
be hazardous. To reduce the risk of
injury, only D
WALT, recommended
E
accessories should be used with this
product.
Consult your dealer for further information on the
appropriate accessories.
Troubleshooting
If your tool seems not to operate properly, follow
the instructions below. If this does not solve the
problem, please contact your repair agent.
Tool does not work
Headlights do not switch on
• Replace the battery pack.
• Release the contact trip lock-off.
• Remove the battery pack, wait for at least
3 seconds, then re-insert it.
Headlights are on but motor does not run
• Release the trigger or contact trip and depress.
• Release the contact trip lock-off.
Headlights are on and motor runs
• Please contact your repair agent.
Tool does not drive fasteners
• Load fasteners into the magazine.
• Make sure to use fasteners of the type
specified.
• Clean the nosepiece.
• Clean the magazine.
Tool does not drive fasteners fully
• Remove nails.
• Remove the battery pack, wait for at least
5 seconds, then re-insert it.
EN GL IS H
WALT, have
E
41