How To Change The Blades - JAC MODENA Traducción Del Manual Original

Use the schematics on page 62.
Make sure that you wear anti-cut protective gloves when replacing the blades or carrying
out operations in the vicinity of the blades.
Once you have ensured that your machine is actually disconnected from the mains:
1. Remove the bagging spade, open the shroud that protects the frames supporting the
blades ;
2. Remove the stainless steel table (or belt) at the front of the machine and disconnect
the bread press (machine equipped with JAC Stop) ;
3. Remove the 4 retaining screws of the crumb chute. On the front left side, replace the
longer screw with the rubber stop ;
4. On the upper part of the machine (right side), on the framework loosen the screw re-
taining the front frame eccentric swivel pin ;
5. Tilt the frame forwards ;
6. Replace the blades of the front and rear frames:
- Loosen the hexagonal socket head screws which tighten the blades ;
- Replace the blades and check that they are well positioned in the rocker arm
pin ;
- Re-tension the blades by tightening screw, so that the blades remain in the
frame as a mark of tension ;
- Then tighten the nuts (machine fitted with the lubrication option).
In order not to warp the frame and avoid dangerous breaks, only replace 4 or 5
7. Re-assemble the front frame and place the frames at the same height; it is essential to
set the alignment of the blades with the help of the eccentric pin ;
Connect your machine to the mains, it is now ready.

HOW TO CHANGE THE BLADES

blades at a time.
10