JAC CHUTE Traducción Del Manual Original página 10

Use the schematics on page 62.
Make sure that you wear anti-cut protective gloves when replacing the blades or carrying
out operations in the vicinity of the blades.
Once you have ensured that your machine is actually disconnected from the mains:
1. Remove the rear cover.
2. Remove the bagging spade, open the shroud that protects the frames supporting the
blades.
3. Remove the stainless steel table (or belt) at the front of the machine and disconnect the
bread press (machine equipped with JAC Stop).
4. Remove the rear baffle plate (on the blade side).
5. On the upper part of the machine (right side), on the framework loosen the screw retain-
ing the front frame eccentric swivel pin.
6. Tilt the frame forwards.
7. Replace the blades of the front and rear frames:
- Loosen the hexagonal socket head screws which tighten the blades.
- Replace the blades and check that they are well positioned in the rocker arm pin.
- Re-tension the blades by tightening screw, so that the blades remain in the frame as a
mark of tension.
- Then tighten the nuts (machine fitted with the lubrication option).
In order not to warp the frame and avoid dangerous breaks, only replace 4 or 5
8. Re-assemble the front frame and place the frames at the same height; it is essential to
set the alignment of the blades with the help of the eccentric pin.
Connect your machine to the mains, it is now ready.
How to change the cutters
blades at a time.
10