Timer; Control Panel Lock; Switching Off The Hob; Demo" Mode - Hotpoint Ariston KIA 641 C Instrucciones De Uso

Using multiple programmes and the display
GB
If one or more hotplates are programmed, the display will show
the data for the hotplate with the least time remaining, and the
light corresponding to the position of the hotplate will flash. The
lights corresponding to the other hotplates programmed will be
switched on.
To display the time remaining for the other programmed hotplates,
press the button repeatedly. The times remaining for each
hotplate will be shown in a clockwise order, beginning with the
front left hotplate.
Changing the programme
1. Press the button repeatedly until the duration you wish to
change is shown.
2. Use the buttons to set the new duration.
3. Confirm by pressing the
To cancel a programme, follow the above instructions. At step 2,
- - - - -
press the button: the duration decreases progressively until it
reaches 0 and switches off. The programme resets and the
display exits programming mode.

Timer

The hob must be switched on.
The timer can be used to set a duration up to 99 minutes.
1. Press the programming button until the timer indicator
light is illuminated.
2. Set the desired duration using the
3. Confirm by pressing the
The timer begins counting down immediately. When the time has
elapsed, a buzzer will sound (for one minute).

Control panel lock

When the hob is switched on, it is possible to lock the oven
controls in order to avoid accidental changes being made to the
settings (by children, during cleaning, etc.). Press the
button to lock the control panel: the indicator light above the
button will switch on.
To use any of the controls (e.g. to stop cooking), you must switch
off this function. Press the
indicator light will switch off and the lock function will be removed.
28
button.
- - - - - + + + + +
and buttons.
button.
button for a few moments, the

Switching off the hob

Press the button to switch the appliance off.
If the control panel lock has been activated, the controls will
continue to be locked even after the hob is switched on again. In
order to switch the hob on again, you must first remove the lock
function.

"Demo" mode

It is possible to set the hob to a demonstration mode where all
the controls work normally but the heating elements do not switch
on. To activate the "demo" mode the hob must be switched on,
with all the hotplates switched off.
+ + + + + - - - - -
• Press and hold the and
seconds. When the 6 seconds have elapsed, the ON/OFF and
CONTROLS LOCKED indicator lights will flash for one second.
+ + + + + - - - - -
Release the and buttons and press the
• The display will show the text DE and MO and the hob will be
switched off.
• When the hob is switched on again it will be set to the "demo"
mode.
To exit this mode, follow the procedure described above. The
display will show the text DE and OF and the hob will be switched
off. When it is next switched on, the hob will function normally.

Practical advice on using the appliance

! Use cookware made from materials which are compatible with
the induction principle (ferromagnetic material). We especially
recommend pans made from: cast iron, coated steel or special
stainless steel adapted for induction. Use a magnet to test the
compatibility of the cookware.
SUITABLE
*
Cast iron
Enamelled steel
Ceramic, non magnetic Stainless steel
Special stainless steel
In addition, to obtain the best results from your hob:
• Use pans with a thick, flat base in order to fully utilise the
cooking zone.
• Always use pans with a diameter which is large enough to cover
the hotplate fully, in order to use all the available heat.
buttons simultaneously for 6
button;
UNSUITABLE
Copper,
Aluminium, Glass, Earthenware,