GEHA Office X7 CD Manual De Instrucciones página 11

LED 'Economy'. Once all paper has been shredded and no additional paper is fed into the
machine, the device stops automatically (Standby Mode). The green LED 'Economy' is no
longer lit.
If you have fed 4 - 7 sheets of paper (A4, 70 g/m²) into the device, the machine will consume
more power and the LED 'Economy' will not light up.
An automatic reverse and stop function prevents a paper jam when the device is overloaded
with too much paper in the feeder. Should a paper jam occur, remove all paper from the
feeder and wait until the device has finished its automatic cleaning process and has stopped
operating. Only insert a maximum of 7 sheets A4, 70 g/m² into the feeder.
'fWD' If you place a narrow piece of paper (< 10 cm) into the feeder sideways, then the pho-
toelectric barrier may not detect it and thus not start the device automatically. In that
case, press and hold the button: 'FWD', until the paper has been drawn in completely.
'rEv' By pressing the button: 'REV', you can initiate the reverse operation of the cutting
mechanism in case of a paper jam.
When the sensor detects that the waste paper container is full, the device will stop automati-
cally, and the viewing window in the waste paper container will be illuminated in blue. First
remove all paper from the feeder, and then empty the waste paper container. Please note the
instructions in the section: 'Maintenance'!
b. feeding cDs/DvDs and credit cards into the shredder
This device is equipped with a separate cutting mechanism for CDs/DVDs and credit cards.
If you would like to utilise this function, proceed as follows:
1. Switch on the file shredder by pressing the power button on the rear of the device. Two
green LEDs, 'Power' and 'Status', light up.
2. CDs/DVDs und credit cards are detected automatically in the CD slot, and the device
activates.
CDs/DVDs are shredded into 10 mm wide strips. Make sure to keep your face well away from
the feeder slot when shredding CDs/DVDs, since these types of material always pose a
hazard of splintering!
The shredded material is collected in a separate waste receptacle to facilitate environmen-
tally friendly disposal.
Important note:
The device will switch off automatically if the motor temperature increases too much. The
LED 'status' will light up red (overheating) and signals that the overheat protection of the
device has been activated. If that is the case, the device will not react when you press the
button 'rEv' or 'fWD'. once the motor has cooled down sufficiently, the device will switch
back into normal operating mode, and the LED 'status' will light up green.
Manual_Office_X7CD.indd 11
11
15.07.10 15:41