Troubleshooting - GEHA Office X7 CD Manual De Instrucciones

TroUbLEshooTING

Faults
The device won't start, after
paper has been fed in.
The device does not switch
off automatically after the
paper has been shredded.
The device is very loud.
The device is not working.
If the device is still not working after you have tried the above solutions, please remove the
mains power plug from the wall socket and consult your retailer.
DIsPosaL
The symbol depicting a crossed-out rubbish bin means that electrical devices
may not be disposed of with regular household waste. Please bring the device to
an approved recycling centre for environmentally firendly disposal.
GaraNTIE
The warranty period for your device is 24 months.
Make sure to keep both your proof of purchase and the original packaging.
Please contact your retailer in case of any problems with the device.
Manual_Office_X7CD.indd 13
Causes
1. The mains power plug was
not plugged into the wall
socket correctly.
2. The paper is too thin.
3. Paper jam.
The in-feed sensor is covered
with dust or paper.
The device is not standing on
a hard, level surface.
1. The amount of paper in the
feeder surpasses the
capacity of the file
shredder.
2. The paper is larger than
the width of the feeder.
3. The paper was not fed in
vertically.
Remedy
1. Replace the mains power
plug in the wall socket,
ensuring proper seating.
2. Fold the paper over and
feed it into the file shred-
der again.
3. Activate the 'REV' function
and pull out any jammed
paper.
Wipe off the dust or remove
the paper.
Reposition the device to stand
on a hard, level surface.
1. Make sure that the
amount of paper in the
feeder does not surpass
the file shredder's capa-
city.
2. Remove surplus paper
and/or activate the 'REV'
function if required. Fold
the paper and insert it into
the feeder again.
3. Insert the paper into the
feeder vertically.
13
15.07.10 15:41