Cosatto the ABCs giggle 3 Manual De Instrucciones página 7

Fitting & operation information:
Please refer to the instruction diagrams (P. 51 - 58):
Chassis 1-
2-
Front wheel 3-
4-
Rear wheel 5-
6-
Brake 7-
8-
Front wheel swivel 9-
lock
10-
Basket 11-
Chassis 12-
Carrycot
13-
14-
Carrycot mode 15-
16-
Opening:
Release the autolock (a) and lift the handle upwards until the chassis locks into
position (b).
Check the chassis has locked in place.
Adjusting handle position:
Fitting:
Removing:
Fitting:
Removing:
Applying:
Releasing:
Applying:
Releasing:
Removing:
Refitting is a reversal of the procedure.
Closing:
NOTE: The chassis cannot be closed with either the carrycot or the child car seat
fitted.
To close with seat unit fitted, the seat unit must be forward facing and in the
most upright recline position.
While pressing the primary release button (a), pull both secondary levers (b) back.
Press down on the handle (c) until the autolock retains the chassis in the folded
position (d).
Fold handle inwards (refer to step 2) to achieve the most compact fold (e).
Preparation:
Remove mattress and liner from carrycot (a).
Unfold both frame bars until they locked into positions (b).
Refit the liner into the carrycot and secure (a).
Refit the mattress over the liner in the carrycot (b).
Fit the bumper bar to the carrycot (c).
There are a set of "D" ring located at the base of the carrycot for the attachment
of a separate safety harness approved to BS EN 13210 should this be required
(harness not supplied). Push the "D" rings through the slots in the liner (d).
Fitting:
NOTE: The carrycot can only be fitted rearward facing as shown in illustration.
Dots are marked on the seat mounts and carrycot mounts (a). These should be
on the same side and aligned if fitted correctly.
Removing:
NOTE: Please ensure that the bumper bar is securely fitted before lifting the
carrycot clear of the chassis.
4