Noise And Vibration - Flex L 3403 VRG Instrucciones De Funcionamiento Originales

 Do not position your body in the area
where power tool will move if kickback
occurs.
Kickback will propel the tool in direction
opposite to the wheel's movement at the
point of snagging.
 Use special care when working corners,
sharp edges etc. Avoid bouncing and
snagging the accessory.
Corners, sharp edges or bouncing have
a tendency to snag the rotating accessory
and cause loss of control or kickback.
 Do not attach a saw chain woodcarving
blade or toothed saw blade.
Such blades create frequent kickback and
loss of control.
Safety Warnings Specific for
Polishing Operations
 Do not allow any loose portion of the
polishing bonnet or its attachment strings
to spin freely. Tuck away or trim any loose
attachment strings. Loose and spinning
attachment strings can entangle your
fingers or snag on the workpiece.
Additional safety instructions
 The mains voltage and the voltage
specifications on the rating plate must
correspond.
 Do not press the spindle lock until the tool
stops.
16

Noise and vibration

The noise and vibration values have been
determined in accordance with EN 60745.
The A evaluated noise level of the power tool
is typically:
– Sound pressure level L
– Sound power level L
– Uncertainty:
Total vibration value (when polishing painted
surfaces):
– Emission value a
– Uncertainty:
`^rqflk>
qÜÉ=áåÇáÅ~íÉÇ=ãÉ~ëìêÉãÉåíë=êÉÑÉê=íç=åÉï=
éçïÉê=íççäëK=a~áäó=ìëÉ=Å~ìëÉë=íÜÉ=åçáëÉ=~åÇ=
îáÄê~íáçå=î~äìÉë=íç=ÅÜ~åÖÉK
klqb
The vibration emission level given in this infor-
mation sheet has been measured in accor-
dance with a standardised test given in
EN 60745 and may be used to compare
one tool with another. It may be used for
a preliminary assessment of exposure. The
declared vibration emission level represents
the main applications of the tool. However if
the tool is used for different applica-tions, with
different accessories or poorly maintained, the
vibration emission may differ. This may
significantly increase the exposure level over
the total working period.
For a precise estimation of the vibration load
the times should also be considered during
which the power tool is switched off or even
running, but not actually in use. This may
significantly decrease the exposure level over
the total working period.
Identify additional safety measures to protect
the operator from the effects of vibration such
as: maintain the tool and the accessories,
keep the hands warm, organisation of work
patterns.
`^rqflk>
tÉ~ê=É~ê=éêçíÉÅíáçå=~í=~=ëçìåÇ=éêÉëëìêÉ=
~ÄçîÉ=UR=Ç_E^FK
Polisher L 3403 VRG
: 82 dB(A);
pA
: 93 dB(A);
WA
K = 3 dB.
: 3,0 m/s
h
K = 1.5 m/s
2
2