Overview; Scope Of Delivery; Assembling Instructions - Grizzly EHS 460-2 T Traducción Del Manual De Instrucciones Original

Overview

1 Safety blade
2 Cutting head
3 Vents
4 Lock button for cutting head that
can be angled
5 Telescopic handle fixing screw +
fixing nut
6 Telescopic handle (hexagonal
aluminium tube)
7 Height adjustment screw + fix-
ing nut
8 Allen key
9 Locking bolt for rotatable handle
10 Deadman switch
11 On/off switch
12 Tension relief
13 Mains cable
14 Grip
15 Lifting lug
16 Allen screw for adjusting the car-
rying eyelet
17 Additional handle
18 Shoulder strap
19 Blade protection

Scope of delivery

Carefully unpack the appliance and check
that it is complete. Dispose of the packag-
ing material correctly.
- Telescopic Handled Hedge Trimmer
(two-part)
- Blade protection
- Telescopic handle fixing screw + fixing
nut
- Height adjustment screw + fixing nut
- Shoulder strap
- Allen key
- Translation of the original instructions
for use

Assembling instructions

Pull out the power plug before car-
rying out any work on the equip-
ment.
If the equipment pipes are not
plugged together and screwed
correctly then the equipment
cannot be switched on.
Operation is prevented by a
safety switch!
Use only original parts.
The Allen key (
in its holder on the telescopic han-
dle ( 6).
Fit the height adjustment screw
(see small picture):
1. Push the fixing nut (7b) into the
slot on the telescopic handle
(6).
2. Fit the enclosed height adjust-
ment screw (7a).
Fit the telescopic handle:
1. Pull out the Allen key aluminium
pipe on the telescopic handle
(6), against the tangible resist-
ance. (The tangible resistance
is due to the cable that is out of
sight in the pipe).
2. Plug the end of the hexagonal
aluminium tube (6) into the
opening provided for this at the
end of the handle below the cut-
ting head (2).
Ensure that the cable does not
become caught. Push the hex-
agonal aluminium tube (6) in
until you hear the safety switch
click and the openings for the
GB
8) can be found
23