RADEMACHER RolloTube C-line Instrucciones Abreviadas Para El Montaje Y La Primera Puesta En Marcha página 3

RolloTube C-line
Brief instructions for installation and initial commissioning
Risk of fatal electric shock when touching electrical
components.
◆ The electrical connection for the tubular motor and all
work on the electrical systems may only be undertaken by
an authorised qualified electrician.
◆ Carry out all installation and connection work only in an
isolated, de-energised state.
◆ Disconnect all phases of the mains power cable and se-
cure it to prevent any reconnection.
◆ Check that the system is de-energised.
The roller shutter may run into the roller shutter box in
self-learning mode and be damaged without rigid shaft
connectors and stoppers.
◆ Connect the roller shutter to the winding shaft (2) with rigid
shaft connectors (1).
◆ Always fit two stoppers or an end-rail to the roller shutter.
The roller shutter must be equipped with rigid
i
shaft connectors and stoppers in order to use
the RolloTube C-line in self-learning mode, see
„Preparation".
The RolloTube C-line tubular motors are self-learning motors
with a soft stop at both end positions. This eliminates the need
to set the end points or a learning cycle.
1.
Switch on the mains power supply.
The RolloTube C-line is ready for operation immediately.
2.
Move the roller shutter up and down.
▲ t
The end positions for the soft stop are
automatically learned during the first drive
cycles.
3.
Subsequently check the direction of travel of the roller
shutter. Switch the lines for the direction of rotation if the
direction of travel is wrong.
DANGER!
ATTENTION!
Set button
Connect the motor cable to the connecting
cable (2.5 m) supplied by means of a connec-
tor and make the connection according to the
following wiring configuration.
Black
Brown
Blue
Green/yellow (d) = PE protective terminal
Grey
* The grey line should be connected to the neutral terminal.
Risk of crushing injuries to the hand when working with
the roller shutter box open.
◆ Never reach into the area of the winding shaft when the
motor is running.
Before you begin, please read this detailed operating manual
of the RolloTube C-line through completely and follow all the
safety instructions and assembly instructions.
(1) (2)
Mount a shaft connector (1) at both ends of the winding shaft (2).
In order to do so, follow the information provided in the operating
manual for shaft connectors.
(a) = L1 direction of travel 1
(b) = L1 direction of travel 2
(c) = N neutral terminal
= no function *
Initial installation
At the initial installation, the roller shutter engineer can carry
out the end point setting with the help of the set button on the
motor or with a commercially available universal setting cable,
see operating manual of the RolloTube C-line.
Universal setting cable
2
1
Cord-switch setting unit
See operating manual of the RolloTube C-line.
CAUTION!
Set button
Roller shutter
button
d c
L1
230 V ~
N
50 Hz
PE
Pin assignment:
The universal setting cable is
connected with the same colours as
3
the motor connecting cable of the
RolloTube C-line, see above.
Button assignment:
Button 1 = direction of travel 1 / 2
Button 2 = set button
Button 3 = no function
Stoppers
a b