Rola 59849 Manual De Instrucciones

Your cross bars come pre-assembled.
Ensure that side rails are clean
and free from dust and grease.
Straps are to be extended to allow
easy mounting of the cross bars.
(Fig 1)
Place the cross bars onto the
vehicle's side rails (note side rails
may have a position marking on
them).
Gradually tighten bolts alternating
sides with the security key
ensuring straps are properly
engaged and even tension is
achieved. (Fig 2)
Reverse procedure to remove.
Crossbar locking end caps may be
removed to access the accessory T-
slot channel. (Fig 3)
Service buffer strips may be
purchased should the buffers need to
be cut around accessories.
Place Cross Bars on the
vehicle at the
recommended positions
shown along the Rail Bars.
( Fig. 4)
REGULARLY CHECK THE TIGHTNESS OF LOCKING STRAPS.
Loads should be evenly distributed and secured
Check the function of all doors and sunroof before driving.
Any weight carried on the vehicle will adversely affect its handling particularly in cornering or in a cross wind and the vehicle
should therefore be driven with increased caution.
For lost key replacement or other service items call customer service: 1-800-632-3290 or visit:
Please have lock core number or part numbers available.
Only use NON-STRETCH tie down straps.
A number of accessories for carrying special loads are available.
59849N Rel 9/6/2011
Sportage with Side Rails
2011-On
Fitting Instructions
Lock Barrel
Actual side rails may be different
.
Printed in China
PART No:
CARRYING CAPACITY:
End Cap
Cross Bar
700mm/ 27-1/2" Min
Ensure bars are parallel and straps are tightened against
the side rails. Perform a check by tugging on the cross bars.
59849
50Kgs/
110 Lbs
Fig 1
Fig 2
Fig 3
Cross Bar
Fig 4
www.rolaproducts.com.
Pg 1 of 1