Data Transmission; Search For Sensor; Weather Station Wrb603 - Oregon Scientific WRB603 Manual De Usuario

• Position the sensor so that it faces the weather
station, minimizing obstructions such as doors,
walls, and furniture.
• Place the sensor in a location with a clear view
to the sky, away from metallic or electronicobjects.
• Position the sensor close to the weather station
during cold winter months as below-freezing
temperatures may affect battery performance and
signal transmission.
You may need to experiment with various locations to
get the best reception.
Standard Alkaline batteries contain significant amounts
of water. Because of this they will freeze in low
temperatures of approximately 10°F (-12°C). Disposable
lithium batteries have a much lower threshold for
temperature with an estimated freezing range of below
-40°F (-40°C). The Liquid Crystal Display in outdoor
thermometers will remain operational to -20°F (-28°C)
with adequate power.
Wireless ranges can be impacted by a variety of factors
such as extremely cold temperatures. Extreme cold may
temporarily reduce the effective range of the unit. If the
unit's performance fails due to low temperature, the unit
will resume proper functioning as the temperature rises
to within the normal temperature range (i.e. no
permanent damage will occur to the unit due to low
temperatures).

DATA TRANSMISSION

Data is sent from the sensor approx. every 60 seconds.
The reception icon shown in the Outdoor Temperature /
Humidity Area indicates the status.
ICON
--- shows in Temp /
Humidity Area

SEARCH FOR SENSOR

To search for the temperature-humidity sensor,
simultaneously press and hold MEMORY and
CHANNEL on the weather station.
NOTE If the sensor is not found, check the batteries.

WEATHER STATION WRB603

This product tracks the time and date based on radio-
controlled signals from the RTGR328NA sensor or
manual settings that you enter.
10
DESCRIPTION
Main unit is searching for sensors
Selected sensor has been found
Sensor 1 is sending data. (The
number shows which sensor is
selected)
The selected sensor cannot be
found. Search for the sensor or
check batteries