Humanscale M/FLEX Instrucciones De Montaje página 3

Attach Mount To Work Surface
Before you install your new M/Flex and monitor arms you will need to set up your
M/Connect 2 or M/Power base.
Before proceeding, please refer to the installation manual that came with your
M/Connect 2 or M/Power for instructions on mounting the base to your work surface.
Bracket Assembly And Cable Clip
Single And Dual Monitor Applications
1
With the Lever (A) open, position the Dual Bracket (B) at the desired height on the Post (C).
2
Close the Lever entirely.
3
If you are using a second monitor, lift and remove the Cover (D).
①
B
C
Triple Monitor Applications
1
Remove the two set screws (E) that retain the Bracket Cap (F). Lift the Bracket Cap (F) upwards to remove it.
2
Install the Extension Bracket (G) on top of the Dual Bracket. Insert the Tabs (H) into the Pockets (J). Replace the Set
Screws. Tighten screws until the Extension Bracket is secure and the screws are flush with the surface.
3
Insert the Bracket Cap into the top of the Extension Bracket. Push down until it clicks into place.
④
F
②
A
E
③
D
⑤
F
H
G
J
3