Conformity Certifi Cates; Ec Declaration Of Conformity - Husqvarna FS 513 Manual De Instrucciones

American National Standards Institute : For units used in the United States, this machine has been designed to
comply with American National Standards Institute ANSI B7.1-2000, "Safety Requirements for the Use, Care and
Protection of Abrasive Wheels". This standard can be purchased by contacting the American National Standards
Institute at the address shown below:
American National Standards Institute
25 West 43rd Street, 4th oor
New York, NY 10036
CALIFORNIA AIR RESOURCES BOARD (CARB): This machine is considered a preempt Off-Road
Apllication as relating to CARB standards. Under construction equipment, and in particular, as a concrete
saw (Saws: concrete, masonry, cutoff), with engine power less than 19KW (25 hp), CARB standards
do not apply to this machine.
For more information see the website

EC DECLARATION OF CONFORMITY

Husqvarna AB, SE-433 81 Göteborg, Sweden, tel: +46-31-949000, declares under sole responsibility that the
Husqvarna FS 513, FS 520, FS 524 dating from 2010 serial numbers and onwards (the year is clearly stated on the
rating plate, followed by the serial number), complies with the requirements of the COUNCILíS DIRECTIVE:
• of May 17, 2006 "relating to machinery" 2006/42/EC
• of December 15, 2004 "relating to electromagnetic compatibility" 2004/108/EC.
• of May 8, 2000 "relating to the noise emissions in the environment" 2000/14/EC.
The following standards have been applied: EN ISO 12100:2003, EN 55014-1:2006, EN 55014-2/A1:2001,
EN 61000-3-2:2006, EN 61000-3-3/A1/A2:2005, EN 13862/A1:2009, EN ISO 14982:2009.
Huskvarna January 3, 2011
Henric Andersson
Vice President, Head of Power Cutters and Construction Equipment
(Authorized representative for Husqvarna AB and responsible for technical documentation.)
CONFORMITY CERTIFICATES
Telephone: 212.642.4900
Fax: 212.398.0023
www.ansi.org
http://www.arb.ca.gov/msprog/offroad/preempt.htm
41