Husqvarna FS 513 Manual De Instrucciones página 29

LUBRICATION:
Depth Control Grease Fitting (X):
fi tting allows lubrication of Blade Depth Control
(EE) screw. To access this grease fi tting:
• Raise the Diamond Blade (H) to maximum height.
Open Tool Compartment (BB), temporarily remove opera-
tion manual bag.
• Grease fi tting (X) is located near top of Blade Depth
Control (EE) Tube.
• Add Grease to the fi tting. Raise and lower the machine
a few times to circulate the grease through the tube.
• Replace Operation Manual Bag, close Tool Compart-
ment (BB) door.
Engine Oil:
Checking Engine Oil:
Check that engine oil level is correct. FS 524
ONLY: Start the engine and let it idle for 1 or
2 minutes. Stop the engine and wait for 2 or 3
minutes. See engine operation manual for more
information.
FS 513:
Engine Oil Dipstick (Z) is located on front of
engine. Refi ll engine oil in dipstick hole. When
checking oil level, Engine Oil Dipstick (Z) should
not be screwed in. See engine operation
manual for more information.
FS 520 / FS 524:
Engine Oil Dipstick (Z) is located on front of
engine. Refi ll engine oil in oil fi ller hole (see en-
gine operation manual). Fully insert Engine Oil
Dipstick (Z), then remove it to check oil level. If
the oil level is low, remove the oil fi ller cap, and
fi ll to the upper limit mark on Engine Oil Dipstick
(Z) with recommended oil type. See engine
operation manual for more information.
Because engine often operates at an angle,
check oil level with engine horizontal. Check
frequently to ensure that oil level never falls be-
low lower mark on dipstick. 10W30 oil is recom-
mended. See engine operation manual for more
information.
MAINTENANCE & LUBRICATION
A grease
FS 513
FS 520, FS 524
29