Husqvarna FS 513 Manual De Instrucciones página 31

FS 513:
Blade Shaft Drive Belt Tension: Drive
re-tensioned after fi rst few hours of operation. Belt Drive
Idler (MM) holds tension on Drive Belt.
Tools Required:
• 13mm Wrench (Included with machine).
• 3/8" (9.53mm) Drive Torque Wrench (Not Included)
• 14mm Wrench (Not included with machine).
1. Use 13mm Wrench (U), to remove three (3) M8 bolts
that attach Belt Guard (LL). Remove Guard (LL).
2. Use the 13mm & 14mm wrenches to slightly loosen the
two (2) bolts that secure the Belt Drive Idler (MM) [bolts
indicated by (2) arrows].
3. Attach Torque Wrench to square hole in Belt Drive Idler
(MM).
4. Apply a torque to Drive Idler (MM) so that Drive Idler
(MM) is forced against the Drive-Belt. Torque to the value
shown in diagram 4.
5. Tighten center bolt (CB1) to hold Drive Idler (MM) in
position, then tighten remaining bolt (CB2).
6. Reinstall Belt Guard (LL). Use 13mm Wrench (U), to
tighten three (3) M8 bolts that attach Belt Guard (LL).
Governor Speed
It is critical that Governor and throttle on all internal
combustion engines be adjusted properly. Engine speed
is preset at factory for proper sawing speed. It is NOT
normally necessary to change this setting. It should be
periodically verifi ed after machine is placed into service.
To change the Governor setting, refer to the engine
manual.
Overspeeding Diamond Blade (H) can result in
blade breakage and/or personal injury to operator
and bystanders! To assure proper Governor
adjustment, determine correct blade shaft speed
(RPM) from the adjacent chart. Follow engine
manufacturer's instruction procedure for Governor
and throttle setting.
MAINTENANCE & LUBRICATION
Belt should be
WARNING!
Blade Shaft & Engine Speed
Model Blade Shaft
RPM
FS 513 2600
FS 520 2100
FS 524 2100
50Nm
(37 ft-lbs)
Engine
RPM
3600
3600
3600
31