Klarstein 10031082 Manual Del Usuario página 15

Screw the fan blades to their
brackets and make sure all screws
are tightened. Please do not press/
4
bend the blade during installation for
preventing from the wobble.
Install the bulb (if needed) into
the bracket (The bulb specification
depends on on-site situation), attach
5
a bottom lamp cover to fan using 3
ball screws.
When mounting the fan, ensure that
the safety wire is looped across the
mounting bracket. Tighten the two
downrod set screws to make sure the
fan run stably. Then, install
downrod (ball part) into mounting
6
bracket opening that already securely
fastened to a structural ceiling
member. The tab opposite of the
mounting bracket opening should fit
in slot on ball.
15