Suntec Wellness Klimatronic IMPULS 2.0 Eco R290 Manual Del Usuario página 14

Operation
•
After switching on or switching over, the fan runs. The compressor and cooling capacity start as soon
as the set temperature in cooling mode is lower than the room temperature.
•
Operating voltage: 220-240V~, 50Hz
•
Control panel:
On/Off
Temperature +
•
Remote control:
•
The unit reaches the following temperatures during operation:
Maximal Cooling: in dry environment 35°C, in wet environment 24°C
o
Minimal Cooling: in dry environment 18°C, in wet environment 12°C
o
•
Make sure that the exhaust hose is installed properly before operation, then plug in the unit, but do not
use a multiple socket. Press „POWER" to turn on the unit.
•
If you use the cooling and dehumidification functions, please keep an interval of at least 3 minutes
between the two operations.
•
Operation mode cooling:
Press „MODE" until the indicating light „COOL" lights up.
o
Press the buttons „TEMP+" and „TEMP-" to adjust the desired room temperature between 16°C
o
and 31°C.
Press „SPEED" to adjust the ventilation speed.
o
•
Operation mode dehumidifying:
Press „MODE" until the indicating light „DEHUM" lights up.
o
The selected temperature will be set to current room temperature minus 2℃. The ventilation
o
speed is set as „LOW" automatically.
•
Operation mode ventilation:
Press „MODE" until the indicating light „FAN" lights up.
o
Press „SPEED" to adjust the ventilation speed.
o
•
Timer for turning on the unit:
Press „TIMER" while the unit is off and set the desired time at which the unit shall turn on by
o
using the buttons „TEMP+" and „TEMP-" between 0 and 24 hours.
Press „TIMER" again to confirm. The display shows the set time.
o
•
Timer for turning off the unit:
Press „TIMER" while the unit is on and set the desired time at which the unit shall turn off by
o
using the buttons „TEMP+" and „TEMP-" between 0 and 24 hours.
Press „TIMER" again to confirm. The display shows the set time.
o
•
Continuous drainage:
If you plan to leave this unit unused for a long time, please remove the rubber blockage from
o
Display
Temperature -
Signal receiver
remote control
1. SPEED:
2. TEMP+:
3. MODE:
4. TEMP-:
5. TIMER:
6. POWER:
Operation mode
Ventilation speed
Ventilation speed
Temperature +
Operation mode
Temperature -
Timer
On/Off button
Timer