Pressure Booster And Sprinkling - SHUR-DRI SDSS5 Guia De Inicio Rapido

Pressure Boosting and Sprinkling
SPECIFICATIONS
Power Supply Required. ...................................115 Volts
Motor Duty ...................................................Continuous
Circuit Requirement (minimum) .....................15.0 Amps
Discharge Adapter .......................................................1"
BOOSTING CITY WATER PRESSURE
Hazardous pressure. Never run the pump
against a closed discharge. To do so can boil the water
inside the pump, causing hazardous pressure in the
pump causing the risk of explosion and possibly scald-
ing persons nearby. See Figure 1.
Figure 1 – Do not run pump with outlet shut off
When using the pump as a high-pressure washer, use
only a reinforced high pressure hose or pipe for the dis-
charge line.
When using a garden hose, install adapters to the pump
suction and the discharge. The suction hose will require
two female ends. Either use a standard washing machine
supply hose or modify a short piece of standard 1" gar-
den hose as a suction line (See Figure 2).
Hazardous pressure. Do not shut off the
hose or the sprinklers while the pump is running.
The hose or sprinkler head may explode. For safety,
add a 75 PSI pressure relief valve.
PERFORMANCE
Model 0 PSI
SDSS5 10 gpm
For parts or assistance, call SHUR-DRI Customer Service at
1117 0993
Flow and Output Pressure
10 PSI 20 PSI
8.5 gpm 8.0 gpm
Figure 2 – Hose adapter installation
Connect the Pump Inlet
to the Water Faucet
for use with Sprinklers.
Figure 3 – Connect pump to a spigot for use with sprin-
klers. Connect with adapters supplied with pump
30 PSI 40 PSI
7.5 gpm 7.0 gpm
1-800-535-4950
4
Hose Adapters
Water Faucet
Hose
Adapters
3942 0401
Maximum
50 PSI PSI
6.0 gpm 80