Maintenance, Precautions - Italpunte S65 Manual De Empleo Y Manutención

about 20 meters horizontally and vertically with respect to the hydraulic breaker itself.
- Immediately turn off the hydraulic breaker in the presence of people in the area of risk.
- Aim the tool on the work surface before starting.
- Never operate the breaker if the tool is not properly locked in the hydraulic breaker with its
specific retainer , as required by the installation instructions.
WARNING Noise hazard
High levels of noise can cause permanent hearing loss and disabling: To reduce risk and avoid
any unnecessary increase in noise levels, it is mandatory to always use appropriate hearing protection.

Maintenance, precautions

WARNING Accidental Starts
An accidental start-up of the hydraulic breaker can lead to serious injury.
Follow the instructions in the manual of the carrier to prevent unintended start of the hydraulic breaker.
The installation of a starter circuit on the hydraulic breaker must be effected in such a manner as to prevent
accidental starting, for example, the pedal on the carrier, must be equipped with protective cover.
WARNING Hydraulic High Pressure
Maintenance of the hydraulic breaker under pressure can lead to serious injury : the connections, to
example, if not properly carried out, can loosen suddenly , as well as the components can move
suddenly and the hydraulic oil may be expelled : To avoid this you must always depressurize the system
Hydraulic before performing maintenance on the hydraulic breaker or the middle.
WARNING Modification of the machine
Any modifications to the machine may cause injury to yourself and other people. It is therefore essential
remember the following rules:
- Never modify the breaker : breakers changed are not covered under warranty or product liability.
- Always use spare parts , tools and accessories provided by inserting approved by Italpunte Srl
- Immediately replace damaged parts and any worn components .
WARNING Tool warm and moving
The tool , in use , it may become hot and could sharpen . The contact with it can cause burns and cuts then .
To avoid the above is therefore recommended :
- Never touch the tool when it is hot or sharp .
- Allow the tool to cool down before performing any maintenance
The accidental operation of the hammer during maintenance or that the tool can cause serious injury :
is therefore essential to disconnect the power supply of the hammer during the operations of inspection,
cleaning or removal tool.
26