Cameo NANOROLL 200 Manual De Usuario página 7

SYSTEM SETTINGS AND SYSTEM INFORMATION
To adjust system settings and access system information, press the MODE button repeatedly until the display shows "Set". Confirm with
ENTER. You can now use the UP and DOWN buttons to select and edit one of the following menu items.
-> ENTER ->
UP/DOWN
<- MODE
-> ENTER ->
UP/DOWN
<- MODE
on = display permanently on
off = display goes out after
about 60 seconds of
inactivity
-> ENTER ->
UP/DOWN
<- MODE
With the help of this menu point, you define
which operating mode is enabled
if the DMX signal is interrupted
when in DMX-mode.
-> ENTER ->
UP/DOWN
<- MODE
Reverse PAN direction
Barrel 1
-> ENTER ->
UP/DOWN
<- MODE
Reverse direction of rotation
Barrel 1
-> ENTER ->
UP/DOWN
<- MODE
Reverse PAN direction
Barrel 2
-> ENTER ->
UP/DOWN
<- MODE
Reverse direction of rotation
Barrel 2
-> ENTER
Firmware version
display
-> ENTER ->
UP/DOWN
<- MODE
Restore to
factory setting
/
/
The last DMX Blackout
command
will be retained.
/
/
/
/
/
Restore to Do not reset
factory setting
-> ENTER
-> ENTER
-> ENTER
-> ENTER
-> ENTER
-> ENTER
-> ENTER
7