Digital Signal Processor; Introduction Of Dsp Adjustments - Pioneer AXM-P7650 Manual De Instrucciones

Controlador de procesador multicanal
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Section
07

Digital Signal Processor

Introduction of DSP
adjustments
Important
! You can use the following functions only when
the remote control is set to DEQ mode.
! Following functions are effective only when
you connected a Pioneer multi-channel pro-
cessor (DEQ-P7650) to this unit.
By carrying out the following settings/adjust-
ments in the order shown, you can create a fi-
nely-tuned sound field effortlessly.
1 Setting the speaker setting
2 Using the position selector
3 Auto TA and EQ (auto-time alignment and auto-
equalizing)
4 Adjusting the time alignment
5 Adjusting the speaker output levels using a
test tone
6 Selecting a cross-over frequency
7 Adjusting the speaker output levels
8 Adjusting 3-band parametric equalizer
20
En
All manuals and user guides at all-guides.com
Operating the DSP menu
1
1 DSP display
Shows the DSP status.
% Press p to display the DSP function
names.
Press p repeatedly to switch between the
following DSP functions:
Posi (position selector)Fad (balance adjust-
ment)SLA (source level adjustment)DRC
(dynamic range control)DIRECT (direct)
Dolby PLB (Dolby Pro Logic B)Downmix
(down mix)
# To return to the display of each source, press
BAND.
Notes
! If you do not operate the DSP function within
about 30 seconds, the display is automatically
returned to the source display.
! If both the center and the rear speakers are
set to OFF in the DSP details menu (refer to
Setting the speaker setting on page 24), you
cannot use Dolby PLB.

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido