Adjusting The Speaker Output Levels; Adjusting The Speaker Output Levels Using A Test Tone - Pioneer AXM-P7650 Manual De Instrucciones

Section
07
Digital Signal Processor
1 Press p and hold until SP Set appears
in the display, then press p to select
C.Over.
After SP Set is displayed, press p until
C.Over appears in the display.
2 Press m or n to select the speaker
to be adjusted.
Each press of m or n selects the speaker
in the following order:
Front speakersCenter speakerRear speak-
ersSubwoofer
3 Press q or r to select cross-over fre-
quency for the selected speaker.
Each press of q or r selects cross-over fre-
quencies in the following order:
6380100125160200 (Hz)
4 Press BAND to return to the playback
display.
Note
Selecting a cross-over frequency is to set a cross-
over frequency of the subwoofers L.P .F. (low-pass
filter) and that of the SMALL speaker H.P.F. (high-
pass filter). The cross-over frequency setting has
no effect if the subwoofer is set to OFF and other
speakers are set to LARGE or OFF.
Adjusting the speaker
output levels
You can readjust the speaker output levels
using a test tone while listening to music.
1 Press p and hold until SP Set appears
in the display, then press p to select
SP Lev.
After SP Set is displayed, press p until
SP Lev appears in the display.
26
En
All manuals and user guides at all-guides.com
2 Press m or n to select the speaker
to be adjusted.
Each press of m or n selects the speaker
in the following order:
Front speaker leftCenter speakerFront
speaker rightRear speaker rightRear
speaker leftSubwoofer
# You cannot select speakers whose size is set
at OFF.
3 Press q or r to adjust the speaker
output level.
Each press of q or r increases or de-
creases the speaker output level. +10  10 is
displayed as the level is increased or de-
creased.
4 Press BAND to return to the playback
display.
Note
To adjust the speaker output levels in this mode is
the same as making the speaker output levels at
T Tone. Both provide the same results.
Adjusting the speaker output
levels using a test tone
A convenient test tone allows you to easily get
the overall balance right among the speakers.
1 Press p and hold until SP Set appears
in the display, then press p to select
T Tone.
After SP Set is displayed, press p until
T Tone appears in the display.
2 Press n to start the test tone output.
The test tone is outputted. It rotates from
speaker to speaker in the following sequence
at intervals of about two seconds. The current