Using The Time Alignment; Adjusting The Time Alignment - Pioneer AXM-P7650 Manual De Instrucciones

Digital Signal Processor
settings for the speaker over which you hear
the test tone are shown in the display.
Front speaker leftCenter speakerFront
speaker rightRear speaker rightRear
speaker leftSubwoofer
# Check each speaker output level. If no adjust-
ments are needed, perform step 4 to stop the test
tone.
# The settings do not appear for speakers
whose size is set OFF.
3 Press q or r to adjust the speaker
output level.
Each press of q or r increases or de-
creases the speaker output level. +10  10 is
displayed as the level is increased or de-
creased.
# The test tone rotates to the next speaker after
about two seconds from the last operation.
4 Press m to stop the test tone output.
5 Press BAND to return to the playback
display.
Notes
! If needed, select speakers and adjust their ab-
solute output levels. (Refer to Adjusting the
speaker output levels on the previous page.)
! To adjust the speaker output levels in this
mode is the same as making the speaker out-
put levels at SP Lev. Both provide the same re-
sults.

Using the time alignment

The time alignment lets you adjust the dis-
tance between each speaker and the listening
position.
All manuals and user guides at all-guides.com
1
in the display, then press p to select
TA MODE.
2
alignment.
# To turn time alignment off, select TA :OFF.
# You cannot select AUTO TA if auto TA and EQ
has not been carried out.
# You cannot select ADJUSTMENT when
neither F/L nor F/R is selected in Posi.
3
ment mode.

Adjusting the time alignment

By adjusting the distance between each
speaker and a selected listening position, you
can insert delay times into the speaker output
to obtain a correct sound image and overall
level balance. Although this is automatically
achieved when you set the listening position,
the time alignment feature provides a fine ad-
justment.
1
in the display, then press p to select
Time A.
After SP Set is displayed, press p until
Time A appears in the display.
# You cannot select Time A when neither F/L
nor F/R is selected in Posi.
Press p and hold until SP Set appears
Press m or n to select the time
! INIT  Initial time alignment (factory set-
ting)
! CUSTOM  Adjusted time alignment that
you can create for yourself
! AUTO TA  Time alignment created by auto
TA and EQ. (Refer to Auto TA and EQ (auto-
time alignment and auto-equalizing) on the
next page.)
! OFF  Turn the time alignment off
Press BAND to cancel the time align-
Press p and hold until SP Set appears
Section
07
27
En