Sauder 419188 Instrucciones De Ensamblaje página 12

Step 8
Carefully turn your unit over onto its front edges. Unfold
å
the BACK (S) and lay it over your unit.
Make equal margins along all four edges of the BACK (S).
å
Push on opposite corners of your unit if needed to make
it "square".
Using your hammer, fasten the BACK (S) to your unit
å
using the NAILS (31).
NOTE: Be sure to tap NAILS into the holes that line up
å
over the UPRIGHT (O).
Peel the backing off of each FELT DISC (32) and stick
å
them on the edge of the ENDS (M and N).
NOTE: Be sure the FELT DISCS are placed approximately
å
1/8" in from the front edge of the ENDS.
Page 12
These holes must line up
over the UPRIGHT (O).
S
M
This FELT DISC should set in 1/8"
from the front edge of the ENDS.
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
31
NAIL
(36 used in this step)
This FELT DISC should set in 1/8"
from the front edge of the ENDS.
N
32