Sauder 419188 Instrucciones De Ensamblaje página 14

Step 10
Carefully stand your unit upright.
å
Before fastening the DOORS to your unit, be sure the mounting screw is
å
against the stops as shown in the right diagram. If it isn't, loosen the mounting
screw to slide it against the stops. Then tighten the mounting screw.
Fasten the DOORS (T and U) to the ENDS (M and N). Use the screws
å
in the HINGES. You should start each SCREW a few turns before
completely tightening any of them.
Fasten the PULLS (25) to the DOORS (T and U). Use four 3/4"
å
MACHINE SCREWS (34).
34
3/4" MACHINE SCREW
(4 used for the PULLS)
Page 14
U
25
Stop
Mounting
screw
N
T
25
Hinge
26
M