Ebode IR Link Serie Guia Del Usuario página 6

 Default, JP on position JP1: Feedback LED active & Status LED not-active/unused
 JP on position JP2: Feedback LED & Status LED both always OFF
 JP cable on position JP2 with voltage supply within range: Feedback LED & Status LED
active (depending on external voltage being present)
 JP on position JP3: Feedback LED active & Status LED always ON (based on power to
IRHUB4)
6. Operation
The IR repeater system should now operate each of the controlled components. When the
system is installed correctly, you should see a Blue "talk-back" LED flash on the front of the
IR Link Pro Mini IR Receiver when you aim your hand held remote control(s) at it and press
the buttons.
7. How to avoid and solve possible problems
Although the ebode IR Link Pro Mini is equipped with proprietary eIR
Technology, which guarantees a high level of immunity of InfraRed noise from direct
sunlight, CFL lighting and Flat Panel TV's (including Plasma, LCD and LED), in rare cases, the
IR Link Pro Mini IR Receiver may have to be moved to a different location if the unit is
picking up unexpected interference. This interference may, in severe cases, prevent the
system from working properly.
After repositioning, check to see if the IR Link Pro Mini operates the satellite Receiver or
other components. If the IR Link Pro Mini still does not work properly, reposition the IRED
Emitter(s). It may not be located directly over the component's InfraRed receiving "window".
Consult the owner's manual of the unit or the manufacturer for the exact location of the
InfraRed "window".
IMPORTANT: For installations involving more than two remote rooms, use the services of a
competent professional audio/video installer experienced in InfraRed remote control
systems.
Do you still have questions? Please refer to
8. Technical information
IR Link Pro Mini IR Receiver Specifications
 InfraRed modulation frequency bandwidth: 30 - 60 kHz.
 Cable length 3m, extendable to max. 300 metres (UTP or equivalent).
 Red 3.5mm TRRS plug pin configuration from tip to sleeve:
Tip = yellow = IR Data = Thin wire 1 grey/white striped
o
Ring 1 = black = Ground = Thin wire 3
o
Ring 2 = red = +12VDC = Thin wire 4 outside, opposite end to grey/white striped
o
Sleeve = white = Status = Thin wire 2 next to grey/white striped
o
 Reception range: Up to 10 meters, depending on local conditions and remote control
used.
 Reception angle: 45 degrees off axis.
 Talkback LED (BLUE). Indicates InfraRed reception only when Emitter(s) are connected.
 Status LED (AMBER). Indicates power status of A/V system
 Maximum number of directly driven IRED IR Emitters: 4 triple Emitters using the
IRHUB4 Connecting Hub. Up to six IR Link Pro Mini IR Receivers may be connected in
parallel at the screw terminals input of IR Link IRHUB series connecting blocks (e.g.
optional IRHUB2CI and IRHUB4). Power requirements: 12 volts DC @ 25 mA. Requires
12VDC Power Supply (included).
 Dimensions IR Link Pro Mini IR Receiver: 35x10x10mm
21-2-2014
All manuals and user guides at all-guides.com
www.ebodeelectronics.eu
6
2 TM
x (pronounced Irex)
IR Link Pro Mini