Worx Professional WU430 Manual Del Usuario página 9

Symbols
To reduce the risk of injury,
user must read instruction manual
Double insulation
Warning
Wear eye protection
Wear dust mask
Wear ear protection
WEEE marking
All manuals and user guides at all-guides.com
1
2
3
9
Operating instructions
Note: Before using the tool, read the instruction book carefully.
SAFETY ON/OFF SWITCH
Your switch is locked off to prevent accidental starting. Depress lock
off button (8) then on/off switch (1) and release lock off button (8).
Your switch is now on. To switch off just release the on/off switch.
HAND GRIP POSITION
Always hold your saw firmly with both hands when operating. The
right and wrong ways to support large workpieces are shown in
Figures A and B.
FITTING AND CHANGING A SAW BLADE
Warning: Before fitting you must inspect the saw blade carefully to
make sure that no breakage or damage has occurred during shipping.
Press the spindle lock button (9), and use the Spanner (12) provided
to remove the blade bolt (15) and outer flange (16). Rotate lower
blade guard (4) clockwise and hold open using the lower blade guard
lever (5) whilst changing the saw blade (6). Ensure the blade bore is
located on the inner flange (14) and the blade direction arrow points
in the same direction as the lower blade guard (4) arrow. Check the
blade surface and flanges are clean. Press the spindle lock (9) again
and re-fit the outer flange (16) over spindle (17) flat and tighten the
bolt with 1/4 turn more than finger tight. Check the blade is securely
clamped.
Warning: Blade teeth are very sharp.
For best cutting results ensure you use a saw blade suited to the
material and cut quality you need.