GB
2.6. How to install or remove the D-AIR STREET SMART CHEST from the specifically designed
garment
To install the D-AIR STREET SMART CHEST, proceed as described below, referring to Figure 1;
1.
Open the garment and the zip of the inner pockets provided to contain the device.
2.
Check that the size indicated on the D-AIR STREET SMART CHEST corresponds to the size indicated on the pocket provided to
contain the device present in the garment.
3.
Insert the back protector into this pocket with the rigid plates facing the outside of the garment,
4.
Position the LED in the special housing (right sleeve with the garment on), passing between the lining and the outer layer of the
garment.
5.
Position the GPS in the special housing (inner spoiler), through the special opening.
6.
Connect the cables to the press studs located on the inside with the garment on (one cable on the right front side and one cable on
the left front side), through the special opening.
7.
Position the airbag in the special pocket, right- and left-hand side, making sure that no parts of the airbag are folded over, that it is
not rolled around itself and that it is lying flat.
8.
After it has been inserted, check that the airbag is lying flat inside the pocket on both sides.
9.
Close the zip of the inner pockets.
Proceed as follows to remove the D-AIR STREET SMART CHEST:
Open the garment and the zip of the inner pockets provided to contain the device.
Remove the System, taking care to disconnect the parts listed in points 4, 5 and 6.
WARNINGS
●●● Connection of the cables as indicated above is essential to enable switching on and correct operation of the System.
●●● If the airbag is not lying flat, this could be dangerous in the event of triggering.
● Should you encounter difficulties or require additional information on how to install or remove the D-AIR STREET SMART CHEST,
contact your nearest DAINESE Technical Assistance Service
P. 50
Note: either of the cables can be connected on the right or left, indifferently.
D-Air
Intelligent Protection System
®