Transport And Storage; The Reciprocating Saw Is Not In Working Order; The Reciprocating Saw Is In Working Order - Hilti SR 30 Manual De Instrucciones

Ocultar thumbs Ver también para SR 30:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Maintenance
WARNING
Danger of electric shock! Improper repairs to electrical components may lead to serious injuries including
burns.
▶ Repairs to the electrical section of the tool or appliance may be carried out only by trained electrical
specialists.
Check all visible parts and controls for signs of damage at regular intervals and make sure that they all
function correctly.
Do not operate the product if signs of damage are found or if parts malfunction. Have it repaired
immediately by Hilti Service.
After cleaning and maintenance, fit all guards or protective devices and check that they function correctly.
To help ensure safe and reliable operation, use only genuine Hilti spare parts and consumables. Spare
parts, consumables and accessories approved by Hilti for use with the product can be found at your
local Hilti Store or online at: www.hilti.group.
7

Transport and storage

Do not transport electric tools with accessory tools fitted.
Always unplug the supply cord before storing an electric tool or appliance.
Store tools and appliances in a dry place where they cannot be accessed by children or unauthorized
persons.
Check electric tools or appliances for damage after long periods of transport or storage.
8
Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable to remedy the problem by
yourself, please contact Hilti Service.
8.1

The reciprocating saw is not in working order

Trouble or fault
Power tool does not start.
The saw blade cannot be
removed from the chuck.
8.2

The reciprocating saw is in working order

Trouble or fault
The power tool does not de-
velop full power.
The saw blade cannot be
removed from the chuck.
9
Disposal
Most of the materials from which Hilti tools and appliances are manufactured can be recycled. The
materials must be correctly separated before they can be recycled. In many countries, your old tools,
machines or appliances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti representative
for further information.
*2243130*
Possible cause
The transport lock is engaged.
The locking lever was not pushed
as far as it will go.
Chuck clogged by residues from
sawing operations.
Possible cause
The control switch is not fully
pressed
The locking lever was not pushed
as far as it will go.
2243130
Action to be taken
▶ Disengage the transport lock.
▶ Push the locking lever as far as
it will go and remove the saw
blade.
▶ Remove the residues from
sawing operations and regularly
clean the chuck from the
outside. Care of the power tool.
→ page 8
Action to be taken
▶ Press the control switch fully.
▶ Push the locking lever as far as
it will go and remove the saw
blade.
English
9

Publicidad

Tabla de contenido
loading

Tabla de contenido