Setting The Heat Level; Setting The Temperature In Automatic Mode - Silvercrest SHLF 2000 C1 Manual Del Usuario

SilverCrest SHLF 2000 C1

8.2 Setting the heat level

Every time you switch it on using the button
.
To select a heat function, proceed as follows:
Press the "MODE" (18) button until the operating mode you want is shown on the display (10):
Low power: The fan heater works at 900 W - 1000 W.
(29)
High power: The fan heater works at 1800 W - 2000 W.
(30)
Automatic mode: The heat output is automatically adjusted to the room
(28)
temperature (33).
Frost-guard function: The fan heater switches on when the room
(31)
temperature (33) is at 6°C.
Fan function: In fan mode, the fan heater works without heating. Above the
actual temperature, the display (10) shows small flashing dashes.

8.3 Setting the temperature in automatic mode

In "Auto" mode, you can define a target temperature in order to achieve a virtually constant
temperature in the room heated.
The setting of the target temperature (34) is important for the operation of the fan heater.
The fan heater switches off when the set target temperature (34) is reached.

Pressing the "+" button (12) increases the target temperature (34) to a value of maximum
38°C.

Pressing the "-" button (13) decreases the target temperature (34) to a value of minimum 6°C.
The target temperature (34) set is shown on the display (10). The current room temperature (33) is
also shown on the display (10).
As soon as the room temperature (33) reaches the set target temperature (34), the fan heater
automatically switches off.
The fan heater automatically switches back on again when the room temperature (33) falls below
the set target temperature (34).
36 - English
(11) , the fan heater starts up in with low heat output