Uline H-5121 Guía Rápida

H-5121
MARINE SHRINK CART
TOOLS NEEDED
3/8" Combination Wrench
or Socket Wrench
A B
3/8" Nuts x 8 Support Pole D-clip x 4
1. Attach X-Support Pole (E) to the bottom of Caster/
Frame (C) using 3/8" nuts (A). Tighten nuts firmly, but
not completely, in order to retain flexibility. Repeat
process for the other Caster/Frame (C).
Note: If the holes at the end of each X-Support
Pole (E) do not line up, lightly tap the ends with
a hammer until holes line up. (See Figure 1)
Figure 1
2. Attach X-Support Pole (E) to the backside of the Caster/
Frame (C) using 3/8" nuts (A). Tighten nuts firmly, but not
completely, in order to retain flexibility. Repeat process
for the other Caster/Frame (C). (See Figure 2)
Figure 2
PAGE 1 OF 3
1-800-295-5510
uline.com
Hammer
PARTS
C
Caster/Frame x 2
ASSEMBLY
D
E
3. Place Support Poles (D) in U-shape holders on front
side of Caster/Frame (C). Keep Support Poles in
place by inserting Support Pole D-clips (B) in the
holes on the U-shape holder. To insert Support Pole
D-clips (B), first open the D-clip by pulling down on
the spring, put through the two holes, and then
release the spring. Repeat process for both Support
Poles (D). (See Figure 3)
Figure 3
4. Double check all nuts and bolts used in assembly.
Tighten each securely.
Para Español, vea página 2.
Pour le français, consulter la page 3.
Support Poles x 2
X-Support Poles x 2
0521 IH-5121