Set The Clock Manually - Bresser ClimateTemp NDV Manual De Instrucciones

NOTE: The interference from the power adapter will
affect RCC (atomic) reception. It is recommended to
place the power adapter at least 1m away from the
console to get the best RCC (atomic) reception.

SET THE CLOCK MANUALLY

1. Press and hold [ MODE ] button to enter into time
and date setting.
2. The setting parameter will flash.
3. Press [ ] button once, the figure will increase 1
unit. Press and hold the [
increase rapidly.
4. Press [ ] button once, the figure will decrease 1
unit. Press and hold the [
decrease rapidly.
5. Press [ MODE ] button to confirm setting and enter to
next parameter.
6. Sequence of setting:
- EU/AUS Version -
12/24h format  Hour  Minute  Year  Month
 Day  Language  Time zone  Key tone on /
off  Temperature unit (°C/°F)  Exit
7. If there is no action in 20 seconds, the setting will be
saved and you will exit the setting mode.
24
] button, the figures will
] button, the figures will
ALARM
SETTING/ADJUSTING ALARM TIME
1. Press and hold [ ALARM ] to enter alarm setting
mode.
2. The setting parameter will flash.
3. Press [ ] or [ ] button to set the desired data.
4. Press [ ALARM ] button to confirm setting and exit.
5. Alarm will turn on automatically when alarm setting
is finished.
TURN ON/OFF ALARM
Press the [ ALARM ] button to turn on/off the alarm.