Getting Started; Insert Batteries - Bresser ClimateTemp NDV Manual De Instrucciones

GETTING STARTED

INSERT BATTERIES

1. Remove the battery door from the back.
2. Insert 3x AAA (LR03)/1.5V batteries. Please ensure
the polarities (+/-) of the batteries match upon
installation.
3. Reattach the battery door.
NOTE: Replace batteries when [
the display is dim.
OUTDOOR SENSOR
The main unit can receive data from up to 3 outdoor
sensors. 1 Sensor is included with delivery.
1. Remove the battery door from the back.
2. Insert 2x AAA (LR03)/1.5V batteries. Please ensure
the polarities (+/-) of the batteries match upon
installation.
3. Select a channel, then press TX.
4. Reattach the battery door.
5. Place the sensor within 30 m (98 ft) of the main unit
using the table stand or wall mount.

TO SEARCH FOR A SENSOR:
The main unit will automatically search for a new sensor
after the batteries are installed. To manually initiate a
outdoor sensor search, press and hold [ CHANNEL ].
NOTE: The transmission range may vary depending
on many factors. You may need to experiment with
various locations to get the best results.
CLOCK
] displays, or when
CLOCK RECEPTION
1. When you insert or replace the batteries, RCC
2. The receiving process duration is 7 minutes.
3. During receiving process, the RCC (atomic) signal
4. If the RCC (atomic) receiving process is successful,
(atomic) reception is initiated. To manually start RCC
(atomic) reception press and hold the [
symbol shows:
[
low level.
a completed RCC (atomic) symbol [
shown in the display and the date and time will
be set automatically. If it fails within 7 minutes,
RCC (atomic) setting will quit automatically. If that
happens, press and hold the [
initiate RCC (atomic) receiving.
] button.
and the backlight is at a
]
] will be
] button to re-
DE
EN
IT
FR
ES
NL
23