Register/De-Register A Handset; Register To A Topcom B2950 Base; Subscribing A Topcom Butler 300 Dect Gap Headset; Removing A Handset - Topcom BUTLER 2950 Manual De Usuario

Topcom Butler 2950

7. REGISTER/DE-REGISTER A HANDSET

7.1 REGISTER TO A TOPCOM B2950 BASE

You can subscribe 5 handsets to one base unit. By default, each handset is subscribed as handset 1 on the base unit
upon delivery (base unit 1).
!!! You only need to subscribe the handset if: !!!
• The handset subscription has been removed from the base unit (e.g. for reinitialisation)
• You want to subscribe a different handset to this base unit.
The underlined procedure is only applicable to a Topcom Butler 28xx and 29xx handset and base unit!!
Keep the Paging key on the base unit pressed for 10 seconds until the Line/Charge indicator
on the base unit begins to blink rapidly. The Line/Charge indicator will blink rapidly
for one minute. During this minute, the base unit is in register mode and you must do the
following to subscribe the handset:
• Press and hold the
• The following will appear on the display:
• Enter the number of the base unit you would like to subscribe the handset to (1-4)
• The unit will start searching for the base and when found it will ask to enter the pin code (4 digits):
• Enter the base pin code (0000). If the pin is wrong, the handset will restart the searching for the base.
• When the handset is registered, it will show 'HS' followed by the handset number.

7.2 SUBSCRIBING A TOPCOM BUTLER 300 DECT GAP HEADSET

Press the Paging key on the base unit for 10 seconds until the Line/charge indicator on the base unit starts to blink
quickly. The line/charge indicator will blink quickly for one minute. During this minute, the base unit is in subscribing
mode and you must do the following to subscribe the headset:
- Turn ON the headset by pressing the ON/OFF button until you hear two beep tones. At the same time the red and
green LED will lit ones.
- Remove the rubber cover of the power socket so that the hole of the power socket is free. Pull out the rubber cover
from the headset so that the registration key hole is free also.
- Press the headset registration key. The red LED will flash rapidly.
- If after a few seconds the green LED flashes slowly, the registration is successful.
- If the red LED flashes slowly, the registration is failed. Repeat above procedure.

7.3 REMOVING A HANDSET

You can remove a handset from a base to allow another handset to be registered:
• Press and hold the mute
10
All manuals and user guides at all-guides.com
and key for 3 sec.
and redial key for 3 sec.
PIN
Topcom Butler 2950