Programming Your Coffee Maker; Cleaning Instructions - Oster BVSTDC10SS Manual De Instrucciones

is on.
Note: The Coffee Maker will remain on for a maximum of 2 hr (hours), after which time it will turn off automatically.
[10] Turn off the appliance when the coffee maker is empty or when the coffee maker is not
in use by pressing the "Auto'' button (On/Off). The light turned off indicates that the appliance
is switched off.
[11] To cycle a second coffee pot, turn off the appliance and wait for 10 min (minutes), allowing
the appliance to cool.
Attention: If the appliance does not have enough time to cool down before being used
again, the water in the reservoir may become too hot, causing vapor to escape through
the opening, which may cause burns.
Attention: Serve the coffee slowly to avoid leaking from the carafe spout.
Warning: Never reheat the coffee by placing the carafe on a hot surface such as a
microwave or stove.
Attention: Only use filtered water in the water reservoir. Never put coffee, sugar or any
other substance in the water reservoir.

Programming Your Coffee Maker

[01] To program your coffee maker, press the "Prog" (Program) button until the word "Timer"
appears in the display. Then press the "HH" button and set the time for your coffee. Next,
press the "MM" button to adjust the min (minutes).
[02] To enable the automatic function, press the "Prog" (Program) button until the blue light
comes on.
[03] When the set time is reached, the blue light will turn off and the red light will turn on,
indicating that the programmed coffee brewing has started. Once it finishes brewing, the red
light will stay on for up to two hr (hours), keeping the coffee at the ideal temperature. After two
hr (hours) the coffee maker will automatically switch off. To turn off the coffee maker, press the
''Auto'' button (On/Off) twice until all the lights go out. Press the "Prog" (Program) button again
to return the coffee maker to the programmed mode. The blue light will remain on to indicate
that programmable mode has been activated. If you want to schedule to brew another period
of time, please follow the steps above.

CLEANING INSTRUCTIONS

Your coffee maker must be cleaned when you begin to notice excessive steaming, or the
brewing time increases considerably. This condition is caused by a build-up of lime and
mineral deposits from your water. If the brewing action stops before all the water has been
cycled out of the machine, the appliance requires cleaning.
The frequency of cleaning depends on the hardness of water used. The following table gives
E n gl is h 5