Uline H-7488 Guía Rápida

H-7488, H-7489
SOLID TOP STAINLESS STEEL
WIRE CARTS
TOOL NEEDED
Rubber Mallet
Handle x 2
1. Slide solid top shelf up the posts one end at a time,
handles facing out. (See Figure 1)
2. Snap the interlocking pieces of a shelf support (wide
end down) around the post at the highest groove
where shelf is to be located. Slide the support up or
down until it snaps into the groove. (See Figure 2)
NOTE: Make sure shelf supports are located
under the shelf.
PAGE 1 OF 3
1-800-295-5510
uline.com
Solid Shelf x 1
Wire Shelf x 1
ASSEMBLY
Figure 1
CASTER INSTALLATION
1. Make sure post is positioned as shown. (See Figure 4)
Figure 4
2. Engage the wheel brakes to keep casters from spinning during
installation. Use a rubber mallet to tap caster stem into posts.
(See Figure 4)
PARTS
Shelf Support x 8 Sets
3. After snapping together all of the shelf supports
at the proper height, slide the shelf down over the
supports to secure the shelf. (See Figure 3)
4. Repeat steps 1 through 3 to attach the remaining
wire shelf in the same manner.
Figure 2
Para Español, vea página 2.
Pour le français, consulter la page 3.
Caster x 4
Figure 3
0421 IH-7488